Full Vehicle Wraps in Dubai: Every Panel, With the Trim Taken Off
A full wrap covers the whole visible body, and done properly it reads as bodywork and not as signage. Full vehicle wraps in Dubai take two to three days in an indoor bay, and most of that time is spent on things that are not vinyl.
Quantity: 1 vehicle · Vehicle: Car or SUV · Finish: Gloss · Remove existing graphics: Not needed
An estimator replies with a firm, VAT-inclusive price and a production date.From your file to the finished job.
Six steps happen between the brief and the finished job. Here they are, in the order they happen on our floor in Dubai South.
The Vehicle Is Stripped First
Door handles, mirrors, badges, lamp units and rubber trim come off. Vinyl is then laid past the panel edge and tucked underneath, so when everything goes back on there is no visible cut line anywhere. A wrap fitted with the trim in place always shows its edges.
It Is Fitted Panel by Panel
Each panel gets its own piece, positioned, heated, squeezed down and trimmed. Bumpers and mirrors are the slow parts because of how far the film has to stretch into recesses without being left under tension.
Heat Sets the Film Permanently
After fitting, every stretched area is post heated to a set temperature so the vinyl loses its memory and stops trying to return to flat. Skip that step and the recesses and corners lift within weeks.
It Protects the Paint Beneath
The original finish spends years under a layer of vinyl, shielded from sun, sand and light scratching. On a vehicle that will be sold on, that protection is a genuine part of the value and not a sales line.
A Clean Indoor Bay Is Required
Dust under vinyl shows as a permanent raised speck. Wind, heat and open air make a good result impossible, which is why this work does not happen in a yard however convenient that would be.
Post Heated and Checked Next Day
We keep the vehicle overnight after fitting and inspect every recess and corner the following morning, since lifting shows itself as the film cools and settles.
The condition that rules it out is paintwork. Any panel that has been resprayed, filled or is lifting needs declaring before we start, because vinyl pulled off soft aftermarket paint takes the paint with it and that becomes an expensive conversation.
Compare with partial vehicle branding, vinyl lettering, and wraps and decals.
What you get.
- Vehicle
- Car or SUV · Van · Pickup · Truck or bus · Other
- Finish
- Gloss · Matt · Satin
- Remove existing graphics
- Not needed · Needed
- Quantities
- 1 · 2 · 5 · 10 vehicles, or any other number
- Turnaround
- Usually 2–4 working days, including application
- Proof
- A digital proof before anything prints
- Delivery
- All seven emirates, or collect from Dubai South
What every order includes
- A free prepress check on your file
- A digital proof before anything prints
- One VAT-inclusive quote with a production date
- Delivery to all seven emirates, or collection from Dubai South
Setting up your file.
- 01Make, model and yearPanel shapes change between model years, so the design is laid out on your exact vehicle.
- 02Photos of every sideStraight-on photos of both sides, the front and the back, including any dents, old stickers or repaired paint.
- 03Send logos as vectorsAI, EPS, SVG or PDF, so lettering stays sharp at the size of a van side.
- 04Mind the gaps and handlesText that crosses a door gap or a handle gets cut or bent. Prepress moves it if needed and shows you on the proof.
Quick answers.
Two to three days in a clean indoor bay.
Not factory paint. It protects it. Respray is the risk.
So vinyl tucks behind edges and no cut line shows.