Curved Top Flags in Dubai: An Arc Across the Head of the Flag
A curved top flag runs as a straight tall rectangle and then sweeps over in an arc at the head. Curved top flags in Dubai sit between a blade and a feather, keeping most of the usable area while softening the hard square corner that makes a blade look severe.
Curved Top Flags: tell us the size, the quantity and the date you need it by.
An estimator replies with a firm, VAT-inclusive price and a production date.From your file to the finished job.
Six steps happen between the brief and the finished job. Here they are, in the order they happen on our floor in Dubai South.
The Arc Is Cut, Not Draped
The curve is a cut line in the fabric following the bend of the pole. It is not the fabric falling into a shape, which means it reads the same whether the flag is still or moving.
Artwork Keeps Its Width
Because the taper only begins near the top, a horizontal logo placed in the middle third stays intact. On a feather the same logo would be squeezed by the taper much further down.
It Reads Softer at Height
At four or five metres the arc gives the flag a finished top edge instead of a cut off one. On a run of several flags outside a hotel or a showroom this is noticeable.
Pole and Sleeve Are Standard
Same curved pole set and full length sleeve as the rest of the family, so a site can mix shapes across one order without different hardware.
It Suits Longer Text
The straight section below the arc is tall and even, which handles a line of text or a stacked address block better than a shape that narrows throughout.
Ordered as a Set
Most clients order three or five of these together for a frontage, with flags reprinted seasonally against the same poles. If you are matching an existing run, send a photograph of what is already standing. The arc radius differs between suppliers and a mismatched curve in a row of five is immediately visible.
A fair warning on the top corner. In strong wind the arc is the part that takes the most movement, and on a tall flag it is where fraying begins. Doubled stitching through the curve is standard on ours and worth checking on anyone else's.
See also blade and feather flags, L-shape flags, and flag printing.
Setting up your file.
- 01Work at full size or to scaleBuild the file at full size, or at a stated scale such as 1:10 when the canvas gets too big, and tell us the scale.
- 02Match resolution to distanceSomething read from a few metres away needs far less resolution than a business card. Around 100 dpi at full size is usually plenty.
- 03Tell us how it will be fixedHems, eyelets, pole pockets and frames take up material around the edge. Tell us the fixing and prepress allows for it.
- 04Send logos as vectorsAI, EPS, SVG or PDF keeps edges sharp at large sizes. Embed or outline the fonts.
Quick answers.
The taper starts much higher, keeping artwork width.
Yes, if they are from the same sail family.
Four to five metres, where the arc reads properly.